Drilling simulation of Fibrous Composites: Technical Note
Main Article Content
Abstract
Drilling of composite material is more complex than conventional drilling, as material removal of isotropic material is uniform than composite material. The cutting edge of drill bit will damage the composite material and removes the fibre in indefinite manner. Improper holes in composite material will cause improper assembly and even can cause premature failure of components made with composite material such as CFRP, Carbon fibre, glass epoxy. By estimating optimal machining parameter such as Feed rate and cutting speed, machining of improper holes in composite material can be eliminated. Optimal machining parameter can be estimated by simulation of composite material. Simulation is performed with help of Abaqus/Explicit software from Simulia
Article Details
Issue
Section
Articles
Authors who publish with this journal agree to the following terms: a. Authors retain copyright and grant the journal right of first publication, with the work two years after publication simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal. b. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal. c. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).