Experimental Investigation and Optimization of SiC Abrasive Water Jet Machining of Aluminium Alloys
Main Article Content
Abstract
Investigation of the parameters variation over the abrasive water jet machining of aluminium 2014 alloy was studied using the Taguchi technique. Traverse speed, standoff distance, pressure and mass flow rate were considered as the process parameters and were varied at three levels. The depth of cut was taken as the response, and it was measured and analysed statistically. The optimal parameters to achieve the maximum depth of cut were identified with the main effect plot. Most influencing parameters over the depth of cut were identified with the analysis of variance and response table. A mathematical relationship was developed to predict the depth of cut.
Article Details
Issue
Section
Articles
Authors who publish with this journal agree to the following terms: a. Authors retain copyright and grant the journal right of first publication, with the work two years after publication simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal. b. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal. c. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).