Experimental Investigation of Tube-in-Tube Nanocomposite Coated Heat Exchanger
Main Article Content
Abstract
In this paper, heat transfer performance is investigated for plain and nanoparticle coated tube-in-tube heat exchangers. Four types of tubes, i.e. bare copper tube, bare aluminium tube, Cu-Al2O3 nanoparticle coated tube and anodized aluminium tubes are used for performing the experimental investigation. The coating thickness of Cu-Al2O3 nanocomposite surface and anodized aluminium tube varies from 10, 25 and 30 micrometres to 15, 20 and 30 micrometres respectively. The surface is found to be hydrophilic in nature as the contact angle changes from 79.82deg to 55.47deg. The prepared surfaces are characterized by FESEM, EDS and FTIR. By adjusting the hot and cold fluids relative mass flow rates, one may calculate not only the overall heat transfer coefficient but also the efficiency of the tube-in-tube heat exchanger. The Cu-Al2O3 nanocomposite coated surface has the highest overall heat transfer coefficient and efficiency, followed by an anodized aluminium surface, bare copper surface and bare aluminium surface. The aluminium anodic oxide (AAO) surface also exhibits an increased heat transfer coefficient, but to a lesser extent than the nanocomposite coating.
Article Details
Issue
Section
Articles
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with this journal agree to the following terms: a. Authors retain copyright and grant the journal right of first publication, with the work two years after publication simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal. b. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal. c. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).