Acoustic Emission based Monitoring of Cut-out Geometry Effects in Carbon-Epoxy Laminates under Uni-axial Compression
Main Article Content
Abstract
In this paper, symmetric cross ply CFRP laminates were fabricated using hand layup with LY556 epoxy resin as matrix and the specimens were cut without cut-out, with circular, vertical elliptical and horizontal elliptical cut-outs according to the ASTM D 7137 standard using water jet cutting. The CFRP specimens with and without cut-outs were subjected to compression under controlled condition accompanied by acoustic emission (AE) monitoring. The ultimate compressive strength for specimens with and without cut-outs were determined and compared. The optimum cut-out with lesser reduction in compressive strength was determined. The nature and dominance of different failure modes in each type of cut-out were investigated using AE. Finally the result gives useful information about improved design of laminated composites with cut-outs suitable for different applications.
Article Details
Issue
Section
Articles
Authors who publish with this journal agree to the following terms: a. Authors retain copyright and grant the journal right of first publication, with the work two years after publication simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal. b. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal. c. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).