Optimization of Diffusion Bonding Process Parameters of Aluminium AA6061-Fly Ash Composites using Taguchi Method
Main Article Content
Abstract
This paper focused to determine optimal bonding parameters based on Taguchi method for maximizing bonding strength. The experiments were conducted on diffusion bonding machine using aluminium fly ash (AFA) composites. Three bonding parameters such as temperature, pressure and time, each at three levels were examined. Taguchi L27 orthogonal array was used as a design of experiment. The response table and the analysis of variance (ANOVA) were calculated to determine which process parameters significantly affect the bonding strength and also the % contribution of each parameter. The results show that the combination of factors and their levels of A2B3C3 i.e. the bonding done at a temperature of 475°C with a pressure of 10 MPa and time for 20 minutes yielded the optimum i.e. maximum bonding strength. Finally, ANOVA results indicated that all three process parameters significantly affected the bonding strength with a maximum contribution from the bonding temperature (85.93%), followed by bonding time (12.6%) and bonding pressure (1.48%). It is also observed that the bonding strength of the diffusion bonding process can be improved effectively through this approach.
Article Details
Issue
Section
Articles
Authors who publish with this journal agree to the following terms: a. Authors retain copyright and grant the journal right of first publication, with the work two years after publication simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal. b. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal. c. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).