Design, Analysis and Topology Optimization of a Connecting Rod for Single Cylinder 4–Stroke Petrol Engine
Main Article Content
Abstract
The aim of the study is to design, analyse and carry out a topology optimization of a connecting rod for single cylinder four stroke petrol engines. In order to obtain a 3D CAD model from existing physical connecting rod is developed through reverse engineering. A three dimensional CAD model of a connecting rod has been created using SOLIDWORKS and it is imported to ANSYS for the coupled steady-state thermal structural analysis, to verify the design of a connecting rod before and after weight reduction. For material optimization, three different aluminium alloy materials such as ADC12, LM6 and Al 6061–T6 alloy were used. From the results obtained from coupled steady-state thermal structural analysis and topology optimization, the optimized design of a connecting rod of Al 6061-T6 alloy shows the von-mises stress of 33.17 MPa, factor of safety 8.32 and total deformation 45.023 mm as compared to other two materials. Based on the topology optimization methodology, it is noted that Al 6061- T6 connecting rod material reduced the weight up to 7.98 % as compared with ADC12 without compromising the strength to weight ratio and ductility.
Article Details
Issue
Section
Articles
Authors who publish with this journal agree to the following terms: a. Authors retain copyright and grant the journal right of first publication, with the work two years after publication simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal. b. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal. c. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).