Multi Response Optimization of Setting Process Variables in Face Milling of ZE41 Magnesium Alloy using Ranking Algorithms and ANOVA
Main Article Content
Abstract
This study presents the optimization of machining parameters on ZE41 Mg alloy fabricated by gravity die casting and Technique for Order Preference by Similarity to Ideal Solution (TOPSIS). Focus on the optimization of machining parameters using the technique to get minimum surface roughness, cutting force, thermal stress, residual stress, chip thickness and maximum MRR. A number of machining experiments were conducted based on the L27 orthogonal array on computer numerical control vertical machining center. The experiments were performed on ZE41 using cutting tool of an ISO 460. 1-1140-034A0-XM GC3 of 20, 25 and 30mm diameter with cutting point 140 degrees, for different cutting conditions. TOPSIS and ANOVA were used to work out the fore most important parameters cutting speed, feed rate, depth of cut and tool diameter which affect the response. The expected values and measured values are fairly close. Finally, the study for optimizing machining process is surveyed and results show improvement in real experiments.
Article Details
Issue
Section
Articles
Authors who publish with this journal agree to the following terms: a. Authors retain copyright and grant the journal right of first publication, with the work two years after publication simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal. b. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal. c. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).